DNA 30 tube mod
DNA tube mod 4DNA 30 tube modDNA 30 tube mod 3DNA 30 tube mod 2DNA 30 tube mod 1

DNA 30 Tube Mod

5.00 out of 5
(2 customer reviews)

£59.99

In stock

Categories: , .

Product Description

DNA 30 tube mod

DNA 30 Tube Mod

 

Made By Tobeco

DNA30 Tube Mod. 18650

We are going to produce a 26650 Tube extension for this mod so please ask if you would like one.

 

USERS GUIDE:

Normal operation watt setting: The power level currently set on the DNA 30. Battery indicator: The current state of charge of the battery.

Volts display: The output voltage being supplied to the atomizer.

Ohms display: The resistance of the atomizer attached to the device. This is measured only when the unit is supplying power to the atomizer. At other times, it shows the most recent measurement.

Other modes:

Locked mode: Pressing the fire button five times with less than .7 seconds between presses will cause the device to enter Locked mode. In Locked mode, the device will not fire and the output power will not adjust accidentally. While in Locked mode, the screen will be off, except that pressing a button will show “Locked, Click 5X”. To exit Locked mode, press the fire button 5 times.

Stealth mode: While locked, pressing the fire and down buttons simultaneously for five seconds will switch to stealth mode. In this mode the display is off. It will still show error and lock messages. To switch back to normal display mode, hold down the fire and down buttons simultaneously for 5 seconds. This setting is stored to internal flash memory, and remains if power is removed.

Right mode & left mode: While locked, holding the fire and up buttons simultaneously for 5 seconds flips the display. This setting is stored to internal flash memory, and remains if power is removed.

Power locked mode: Holding down both the up and down buttons for two seconds will place the device in Power Locked mode. In this mode, you will not be able to change the power setting. This mode prevents accidental power level changes due to the buttons being pressed while in a pocket. To exit Power Locked mode, hold the up and down buttons for two seconds.

Error Messages: The DNA 30 will indicate a variety of error messages, as follows:

Check atomizer: The DNA does not detect an atomizer, the atomizer has shorted out, or the atomizer resistance is incorrect for the power setting.

Shorted: The atomizer or wiring are short circuited.

Check battery: The battery is below 3.1 volts. It probably needs to be charged.

Weak battery: The battery sags excessively when firing. This typically means the user is not using a high rate battery, or the battery is old and degraded. It can also mean the battery is not making good contact.

Too hot: The DNA 30D has onboard temperature sensing. It will shut down and display this message if the internal board temperature becomes excessive.

Too low power setting: The DNA 30D puts out a minimum of 4 volts. With low power settings (7 to 8 watts) and low resistance atomizers (below 2 ohms) the DNA will sometimes be unable to provide a low enough power output to be power regulating. If this is the case, the Ohms display will be flashing. The device will still operate.

Device resets: If the battery is not able to power the device at the desired setting, or the battery is excessively discharged, the device may go immediately into a low voltage shutdown. If firing the device causes the screen to blank out and then display the welcome screen, you should charge, replace or upgrade your battery. This is especially common at power settings above 20 watts.

Auto power down: The screen will be at full brightness while firing. After 15 seconds with no button presses, the screen will dim. 2 minutes after the last button press, the screen will fade out and the device will go to sleep mode. Pressing any button will turn the device and display back on.

DNA30 Specs:                          Minimum               Typical                        Max

Output Power                            7 Watts                                                    30 Watts

Output Voltage                          4 Volts                                                     8.3 Volts

Output Current                                                                                             10 Amps

Atomizer Resistance                  .3 Ohms                 1.5 Ohms                3.3 Ohms

Input Voltage                             3.2 Volts                  3.7 Volts                  4.3 Volts

Input Current                             1.5 Amps                 6.0 Amps                7 Amps

Efficiency                                                                   94%

Because of the machining process of the material (billet 6061 aluminum), along with the chemical reaction anodizing has on the effect of the material, some imperfections may arise. 

Additional Information

Colour

Black, Royal Blue, Red, Silver

2 reviews for DNA 30 Tube Mod

  1. NEIL
    5 out of 5

    (verified owner):

    got this beast this morning 24/6/14,very impressive bit of kit well built great quality threading and feels good in the hand.30 watts crikey!ive been running my aspire nautilus,aerotank,kayfun lite and they are all banging out the vape tried going past 15 watts but get a stinging vape so now running around 12 watts which is my sweet spot. so would i recommend yes!! 100% love the feel of it it looks like its built to last. Anoher great quality product from vapenquit,love the site, james always has the latest products his site is always having new gear and his prices are always very competitive. its always nice to talk to him as hes not into selling stuff you dont need he always this 100% honest advice and is always on hand if you need help i simply cant fault his company

  2. NEIL
    5 out of 5

    (verified owner):

    ok ive come back with a follow up review having run this DNA 30 TUBE MOD for over 24 hours. Its simply faultless ive been running it mainly on my naultilus aspire the vapour production and taste is superb.Ive also used james rebuidable coil kit for the naultilus and the vape production really throws some serious vapour

Add a review